MIBO Kavan Set-up Programmer for MIBO Servo

USB interface - programmer of servos MIBO. Thanks to the use of the computer monitor as a user interface, you have a programming and testing instrument with convenient operation. During programming, the servo is powered through the USB port of the computer to which the programmer is connected. All parameters are first set in a window on the screen and then loaded into your servo. The operating program can be found in the "Downloads" section.

System requirements for using the programmer:

• Supply: USB (5 V/500 mA)
• Operating system: Windows® XP/Vista/7/8/10 (32/64bit)
• USB port: USB 2.0
• Compatible servos: MIBO

Programmable functions:

• Deflection size: Used to set the maximum size of servo deflections. The default setting is about 120° at the normal range of control pulse widths (900~2100 µs); about 180° at the maximum allowable range of control pulse widths (500~2500 µs).
• Neutral position of the servo: Used to set the neutral (center) position of the servo.
• Damping: Adjusts the characteristic of the servo behavior when stopping its movement.
• Output Power: Sets the output power of the servo. The higher the value, the faster the servo and the higher the power - of course, the power consumption is also proportionally higher. Range: 39.2~100%
• Sensitivity: Sets the sensitivity (insensitivity bandwidth) of the servo. The higher the value, the narrower the insensitivity bandwidth - the servo will move only if the change in control signal width is greater than the insensitivity bandwidth. If you set the sensitivity value too high, the servo may oscillate in some applications. Range: Ultra High (Extra high - insensitivity band about 1 µs) - High (High - about 2 µs) - Medium (Medium - about 3 µs) - Low (Low - about 4 µs)
• Soft start: Turns the soft start function on/off. This function prevents the servo from abruptly entering the operating position after being connected to the power supply, thus reducing the risk of damage to its gear.
• Servo Reverse: Reverses the servo deflections.
• FUTABA SR mode: Only for use with channels of RC sets FUTABA operating in SR mode. Do not turn this option on if you are using a different setup of RC set FUTABA or a different brand of RC set.
• SANWA SSR mode: Only for use with channels of RC sets SANWA operating in SSR mode. Do not turn this option on when using a different setup of RC set SANWA or a RC set of another brand.
• Fail-safe: If the receiver's control signal fails completely or the servo cannot detect the signal properly (e.g., due to interference), the servo can enter one of three emergency modes:
• (a) Free: Fail-safe is switched off.
• (b) Hold position: The servo maintains the position corresponding to the last correctly received signal.
• (c) Transition to neutral position: the servo returns to the neutral position (pulse width 1500 µs).
• Overload protection: Enables or disables servo overload protection in three stages - once the overload persists for a preset time (in seconds), the servo output power is limited to the corresponding preset value (in % of maximum power).
• Reset: Restores the factory settings of the connected servo.

The programmer set includes:

• Programmer from Servos
• Instruction manual